Pool Pro pH Buffer 4kg

Pool Pro pH Buffer 4kg
Share

Pool Pro pH Buffer 4kg

Manufacturer: Pool Pro

pH is adjusted up using Pool Pro Buffer. Buffer increases the pH and the Total Alkalinity. To raise only the pH Pool Pro pH Increaser is used. Be careful as it raises the pH very quickly so only small doses are recommended, then test again. 

Active Consistuent: Sodium Bicarbonate 

General Instructions:

  1. Test for total alkalinity with a reliable test kit using fresh testing reagents & if necessary make the adjustment according to the directions for use.
  2. pH buffer should be dissolved in a bucket of water and dispersed around the pool or spa.
  3. Run the filter whilst adding pH Buffer to ensure adequate distribution throughout the pool or spa water.
  4. Allow 3-4 hours before testing the total alkalinity level again. Make further additions if necessary using the dosage rate as a guide.

Note: pH BUFFER (Sodium Bicarbonate) is used to raise total alkalinity levels in swimming pool and spa water to 'buffer' the pH. If total alkalinity levels are too low, pH 'bounce' (or excessive fluctuations) will occur.

The minimum total alkalinity level in a pool or spa should be 60mg/L (p.p.m)

Direction for Use:

Pool capacity in Litres             Dose required to raise total 
                                                total alkalinity by: 10p.p.m.
       
        10,000                                               170g
        20,000                                               340g
        30,000                                               510g
        40,000                                               680g
        50,000                                               850g

MSDS: https://www.poolpro.com.au/images/stories/virtuemart/product/buffer_all-grades17.pdf